SOLD FS Boxflyer Cam Timing Tools

[Boxflyer]

For Sale

Boxflyer Cam Timing Tools for either the R1200 WetHead or the R1250 ShiftHead 

 

Includes: 

1. Cam Alignment Jigs, R1200 WetHead or R1250 ShiftHead
2. 8mm TDC Locking Pin
3. Boxflyer Cam Chain Tensioner w/42mm Setup Sleeve (used on both WetHead/ShiftHead)
4. 16mm Torque adapter
5. Engine Turning Bar
6. Crush washers and/or O-rings for Cam Chain Tensioners

 

 

This is the normal set of tools that I have for doing Cam Timing on either the R1200 or R1250 WetHead/ShiftHead series bikes (choose one) starting with the 2013 R1200GS or 2014 R1200RT up thru the 2023 R1250 ShiftHead.

 

Edited March 20 by Boxflyer
SOLD

[Rougarou]

Shoulda said "but wait,....there's more"....."and if you buy in the next five minutes, we'll include".......somewhere in there.  good luck selling those tools

[Dirtmerchant]

You lost me at K1600GT....  

[Boxflyer]

OK, you don’t have to take the K1600GT. 

[szurszewski]

3 hours ago, Boxflyer said:

OK, you don’t have to take the K1600GT. 

So just $9k for the tool set? Is there also a shipping charge? ;)

 

 

[Boxflyer]

No, out of the goodness of my heart, I'll include shipping for the Tools Set.

[Matts_12GS]

I want that bike, but, being retired, I'm not sure if I can afford the tires. 

Besides, I might have to clean up my garage to put it in there, and then my wife might find it. 

[Boxflyer]

I hope you can work it out…

 

Cleaning out your garage is what we all have on a “to-do” list, so that’s not a show stopper. 

[duckhawk64]

To Do: Winterizing the garden beds, cleaning out the garage, final oil change and pulling batteries on two bikes and then organize the basement shop for the front suspension overhaul and top end on the 78 RM125.

I sold 5 bikes this Summer, so I am feeling  lean.

[OleGuy]

Good morning ....

I am new to this site and forum so I'm trying to get it figured out. After all, I am old!

I'm very much interested in purchasing the complete set of tools required for the R1250 Shiftcam cam alignment service. I just don't see how and/or where to accomplish this.

The "BoxFlyer" reference suggest that the tools are currently being machined and ready for sale. Is this correct? Any help would be appreciated.

 

Thanks,

OleGuy

[Boxflyer]

@OleGuy

This set is still available...but is not going to be separated from the K1600GT.

 

You can always "FLIP" the K1600GT and keep the tools as a "Bonus".

Brad